Cubase 6 -> JS3 -> EZ-Drummer/StevenSlate 64Bit

McHannemann · Post by **McHannemann** » Fri Apr 08, 2011 9:04 am

Hello,

When I use JS3 in Cubase 6 64 Bit it works fine,
then when I additonally want to use the external EZ-Drumkit From Hell or StevenSlate Drums I have the following problem:

JS3 doesn't accept the plugins
Kontakt 4 64-bit
EZDrummer 64 Bit
That's ok as JS3 is 32 Bit so I say keys only.
But I then want to use the midi route into these two plugins,
I see midi activity inside JS3 at the bottom,
but I don't see any reaction inside Cubase/ EZ Drummer/Kontakt
What do I miss, must be something simple...

Thor

jas_lan · Post by **jas_lan** » Fri Apr 08, 2011 9:51 am

Thor,
Are you using the built-in VST bridge in Cubase or are you using JBridge?
Which version (6.0.1?) of Cubase are you using?
Sincerely,
J.L.

McHannemann · Post by **McHannemann** » Mon Apr 11, 2011 6:04 am

I use the built-in Bridge and 6.01

Post by **Ralph @ Rayzoon** » Mon Apr 11, 2011 8:07 am

Cubase BitBridge so far cannot handle JS3 MIDI output data.

Sherz · Post by **Sherz** » Mon Apr 11, 2011 8:51 pm

I am able to use JS3 and Kontact 3/4 under C5.5.3(64) & C6.01(64).
I run Steve Slate drums and Alicia Keys piano. I have to say though that the set up is somewhat unstable with "VST bridge has lost connection" type errors occuring from time to time.

The lack of MIDI out in this environment is unfortunate as I used to prefer to do manual edits to the drum composition using Cubases's MIDI drum editing.

JS3 also causes a lot of CPU spikes for me too.... but I suspect that's another issue.

8)