Page 1 of 1
Snare Roll Velocity
Posted: Mon Feb 16, 2009 6:19 pm
by Sheppol_A
Can't seem to figure this one.I have a groove going with some great snare roll build ups but they are too quiet up the the main snare hit.I need to increase their volume.I know I could go into the Bar editor and manually increase the velocity but is there and easier way e.g O don;t want the snare roll build up to start at such a quiet point?
TIA
Snare Roll Velocity
Posted: Mon Feb 16, 2009 8:48 pm
by Ralph @ Rayzoon
Where did the rolls come from? Manual or style?
Snare Roll Velocity
Posted: Mon Feb 16, 2009 8:49 pm
by Sheppol_A
They came from a Style or a fill.
Snare Roll Velocity
Posted: Mon Feb 16, 2009 8:51 pm
by Ralph @ Rayzoon
Manual-editing is pretty much the only option. An alternative is to adjust the velocity curve of the snare (or snare bounce) in the kit editor to raise the lower velocity range.
Snare Roll Velocity
Posted: Mon Feb 16, 2009 8:55 pm
by Sheppol_A
Thanks.will give it a go
Snare Roll Velocity
Posted: Mon Feb 16, 2009 8:58 pm
by Sheppol_A
Upping the volume of the,"Snare Bounce" did it.
Thanks again Ralph
Snare Roll Velocity
Posted: Tue Apr 07, 2009 1:55 am
by bigcat_JC
Ralph [RZ] wrote:Where did the rolls come from? Manual or style?
OK, relative newbie here - how do you add rolls manually?
Snare Roll Velocity
Posted: Tue Apr 07, 2009 2:23 pm
by dysfunction
bigcat_JC wrote:Ralph [RZ] wrote:Where did the rolls come from? Manual or style?
OK, relative newbie here - how do you add rolls manually?
Right click at the top of the bar editor, choose 'Add Snare Roll', choose type of roll.
Snare Roll Velocity
Posted: Wed Apr 08, 2009 12:02 am
by bigcat_JC
Holy cow! I bet this is the type of thing I'd know if I read the manual a little closer. Thanks!