loud white noise 2.5.1

Post by **Ralph @ Rayzoon** » Wed Apr 29, 2009 9:46 am

Please check your mail...

politcat · Post by **politcat** » Wed Apr 29, 2009 10:34 am

still getting noise with older version, BUT...

I just discovered that the noise only happens when i preview before loading the offending kits. (i always use preview so i didn't think of turning it back off) If I just load without previewing all is ok.

I can live with that as long as the kits are still useable. it's only a problem with a few kits so I don't mind

Post by **Ralph @ Rayzoon** » Wed Apr 29, 2009 10:45 am

Interesting. I'll look into that. Do you preview the kit in the kit loading screen or individual sounds in the klit editor?
Also, please revert to the 2.5.1 DLL and see if the problem is connected to 'preview' there as well.

politcat · Post by **politcat** » Sat May 02, 2009 7:37 am

I mainly preview in the kit loading screen. but sometimes I mix samples so I preview in the individual sounds editor too

one of the samples I have problems with is the KICK - 22" STANDARD. if I preview a kit that uses this kick in the kit loading screen, it continues to make noise after loading.

but, if I load a kit that uses KICK - 22" STANDARD without previewing in the kit loading screen, there's no noise after loading

if I load a kit that uses a different kick then go to the individual sounds editor and preview KICK - 22" STANDARD it makes noise. however, the noise stops after loading it from there. weird!

so the problem is with previewing, more so in the kit loading screen

yikes. I hope that's easier to understand than it was to explain

this happens in 2.5.1