Snare Roll Velocity

Sheppol_A · Post by **Sheppol_A** » Mon Feb 16, 2009 6:19 pm

Can't seem to figure this one.I have a groove going with some great snare roll build ups but they are too quiet up the the main snare hit.I need to increase their volume.I know I could go into the Bar editor and manually increase the velocity but is there and easier way e.g O don;t want the snare roll build up to start at such a quiet point?

TIA

Post by **Ralph @ Rayzoon** » Mon Feb 16, 2009 8:48 pm

Where did the rolls come from? Manual or style?

Sheppol_A · Post by **Sheppol_A** » Mon Feb 16, 2009 8:49 pm

They came from a Style or a fill.

Post by **Ralph @ Rayzoon** » Mon Feb 16, 2009 8:51 pm

Manual-editing is pretty much the only option. An alternative is to adjust the velocity curve of the snare (or snare bounce) in the kit editor to raise the lower velocity range.

Sheppol_A · Post by **Sheppol_A** » Mon Feb 16, 2009 8:55 pm

Thanks.will give it a go

Sheppol_A · Post by **Sheppol_A** » Mon Feb 16, 2009 8:58 pm

Upping the volume of the,"Snare Bounce" did it.

Thanks again Ralph

bigcat_JC · Post by **bigcat_JC** » Tue Apr 07, 2009 1:55 am

Ralph [RZ] wrote:Where did the rolls come from? Manual or style?

OK, relative newbie here - how do you add rolls manually?

dysfunction · Post by **dysfunction** » Tue Apr 07, 2009 2:23 pm

bigcat_JC wrote:
Ralph [RZ] wrote:Where did the rolls come from? Manual or style?
OK, relative newbie here - how do you add rolls manually?

Right click at the top of the bar editor, choose 'Add Snare Roll', choose type of roll.

bigcat_JC · Post by **bigcat_JC** » Wed Apr 08, 2009 12:02 am

Holy cow! I bet this is the type of thing I'd know if I read the manual a little closer. Thanks!